What is the best practice of configuring an intercom on a shared line?
A. This feature allows all endpoints to participate in intercom messages.
B. This feature can be used only when the intercomephone-dn is configured as a dual line
C. This feature is not supported and should not be used
D. This feature can be supported only in a unidirectional manner.
E. This feature allows one endpoint to contact multiple endpoints simultaneously
Using the show ccn trigger command provides the following output:cue-10-0-0# show ccn trigger
Name: 6800Type: SIPApplication: voicemailLocale:en_US Idle Timeout: 5000Enabled: yes
Maximum number of sessions: 8Name: 6700Type: SIPApplication: autoattendant Locale:en_US
Idle Timeout: 5000Enabled: yes Maximum number of sessions: 8cue-10-0-0# What two pieces of
information can you derive from this output? (Choose two.)
A. The number of ports available is 16
B. The operator can bereachedat extension6800
C. The voice-mail pilot point number is 6800
D. The voice-mail application is enabled.
E. The idle timeout is 5 seconds
Refer to the exhibit. What type of calls can the ephone with extension 2151 make?
A. No impact on out going calls. However, in coming calls will not be permitted to extension
2151unless cor list is configured on the ephone-dn
B. Only US calls
C. All calls
D. Internal and emergency calls only, because of the defaultcor restriction.
Refer to the exhibit. A user at Acme Co. reports that when someone leaves a voicemail message,
their MWI does not light up. The administrator has checked the MWI configuration in Cisco Unified
Communications Manager Express and found that the MWI On number is 9001 and the MWI Off
number is 9000. Using the trace output from the Cisco Unity Express module, what is the
A. The MWI On number configuration is incorrect in Cisco Unity Express
B. The CCN subsystem SIP is incorrect in Cisco Unity Express.
C. The MWI Off Number configuration is incorrect in Cisco Unity Express
D. The SIP is misconfigured in Cisco Unified Communications Manager Express
E. The MWI application is not enabled